How to clone HD to SSD with 4DDiG without losing data: Complete Guide

One of the greatest wonders of the modern world is the new technologies that emerge over time. A practical example was the arrival of the SSD, a component that made life easier (and much easier) for computer and notebook users, as with it it is possible to achieve speeds and performance that were not viable with a common HD.

And to take advantage of all this technology, did you know that it is possible to transfer all (or a large part) of your data from your HD to an SSD? The software 4DDiG Partition Manager is a powerful, safe and efficient tool to help you clone HD to SSD or SSD to HD directly. In this article, we explain how it works and how to clone HD to SSD and vice versa.

Safety and efficiency first

The software has an enhanced data protection technique to ensure no data loss. All operations are pending until you click “Apply”. Plus, it's super easy to use, thanks to its intuitive interface and step-by-step wizards that simplify all complicated hard drive partition management operations.

However, before starting any procedure on hard drives, it is important that any and all important files are saved in a backup. Although 4DDiG Partition Manager is extremely safe, it is not free from process failures. Therefore, it is most prudent to save your photos and documents elsewhere before starting the process.

Is it possible to clone HD to SSD without losing data?

Definitely yes! And that is the intention of 4DDiG Partition Manager. But what to do before starting the procedure with the software? In addition to performing the backup, as mentioned above, you need to have a new hard drive or SSD with a greater capacity than the original drive.

To ensure fast Windows performance on the new disk, make sure it has a generous capacity, leaving 30% to 40% free space. For example, if your current disk is 120 GB, the new disk must be at least 256 GB.

Additionally, it is important that the new drive is configured correctly on your computer:

• Install the new disk into your PC via SATA cable or NVMe SSD slot.
• Boot the SSD with the same disk type as the operating system: MBR or GPT.

How to clone HD to SSD with 4DDiG?

1. Connect an external disk to your computer after download and install 4DDiG Partition Manager on your computer Windows. Then launch the application, select “Clone Disk”.

2. Select a target disk to receive cloned data from the source disk and click the button Continue. (The target disk defaults to the disk you connect to your computer).

3. Please note that cloning will overwrite all data on the target disk; therefore, after confirming that everything is correct, click the button Yes.

4. Then you will see a preview interface showing the effect of the cloned disk. After confirming that the visualization is correct, click the start button to start the cloning operation.

5. Wait until disk cloning is complete. Cloning speed depends on the size of the source disk. Please wait patiently and do not perform other operations or interrupt the current operation. 

Conclusion

With the assistance of the resource 4DDiG Partition Manager, it's possible perform hard drive cloning in a simple way and without complications. It is important to be aware of the possible risks involved in the process and know that 4DDiG support is available to assist in case of problems during cloning or updating.

See also:

Nowadays, having an SSD in your computer is practically a requirement for a good user experience. Find out what SSD is and its types.

reviewed by Glaucon Vital em 2 / 1 / 24.